|
|
|
|
|
|
|
|
|
|
|
|
|
Dana 30 / 44 / 60 Front Axle Seal Installer
Includes, Install puck and stud, nut, and thrust block
|
Wide 5 Hub Nut Socket - 3/4 ton
Also fits Howe Vogel 2 inch Hub Nuts
|
1 Ton Socket for 1 ton dirt late model snout nut
fits PEM QCC0230K 1 ton hub nut & Winters 1 ton nut
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Grand National Hub Nut Socket for 2.5 inch bearing hubs
fits N-12 GN Nut
|
Helpful wrench used to hold pinion yoke while setting torque. Fits 1210 to 1550 u joint series.
|
Pinion Posi Nut Socket for a quick change Rear end
for 1-7/8" nut
1/2" Drive Steel Socket
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
- Easily set carrier bearing preloads safely
- Can be used for Dana 30 thru Dana 80 Housings
- Does not work with Corvette Housings
- Does not work with Dana 35 Housings with dowels under the cover
- Can be used for GM10 and 12 Bolt Housings by making custom pins from a 7/8 Fine Thread Bolt
- Dowel Pins measure 13 11/16 inches from center of pin to center of pin when fully adjusted out, and then down to 11 3/8 inches at its narrowest point.
|
Clamshell Bearing Puller - click link for more description
|
When assembling differentials, being able to securely position the assembly is essential. The heavy duty steel construction of the PEM Bench Yoke makes it the perfect tool for assembling and rebuilding center sections. The Bench Yoke rotates so you can work on any side.
Bench Mule comes in raw state, not painted
|
|
|
|
|
|
|
|
|
|
|
|
Press kit to remove your rear end tube from your quick change side bell.
Steel press plates for your hydraulic press
Two steel slugs to go inside the tube to push out the tube
one for .188" wall tubes
one for .250" wall tubes
You just have to provide your hydraulic shop press and the tubing to go down inside to push the slugs.
Sometimes heat is still needed.
|
|
|
